Bud Weisbrod’s Comment About
SuperSteer® Bell Crank Steering Controls
From: Bud Weisbrod [mailto:weisbrod@myexcel.com]
Sent: Monday, October 16, 2006 12:31 PM
To: MotorhomesP-30GM@yahoogroups.com
Subject: P-30 Bell Crank adjustments
“In my very prejudiced opinion, there are only two real fixes (to P-30 Bell Crank Supports). One would be to either rebuild or buy a rebuilt bell crank shaft support assembly. You will end up with the same poor design and in a few thousand miles will once again have a loose lower bushing. (Some will disagree with me!)
“The other fix is to replace the Chevy OEM unit with the Henderson [SuperSteer] Bell Crank assembly. They have adjustable Timken Tapered Roller Bearings and a grease cap. However, they NEVER need adjustment or lubrication…. Yes, they are expensive, but if you install them, and have a wheel alignment, they will not require further attention. I’ve installed a bunch of them and have never seen one ‘loosen up’….
“In other words, penny-wise, pound-foolish….
Bud Weisbrod, ‘New member of the P-30 Yahoo group’ ‘Long time member of the Bounder Yahoo group…’”
SuperSteer®
Division of Henderson's Line-Up
458 Redwood Highway
Grants Pass, OR 97527
- Phone us at: 541-955-0769
- “800″ Phone: Toll-free - 888-898-3281
- Fax us at: 541-476-3851
- SuperSteer Tech Line: 541-955-0769
- SuperSteer Order Line: Toll-free - 888-898-3281
- Office Hours: (PST) 7 a.m. - 4 p.m. Mon-Fri; Closed Noon
to 1 p.m. If you call after hours, we'll call you back. If you’re driving & unfamiliar with the Grants Pass area, see a map here
E-mail us and tell us what you need at:
Monday - Friday 7 A.M. to 4 P.M.
Closed Noon to 1 P.M.
Share this:
